DVI-D TO VGA CONVERTER
DVI-D TO VGA CONVERTER
DVI-D TO VGA CONVERTER
Copyrights and Trademarks
©2007. All rights reserved. This information may not be reproduced in any manner without the
prior written consent of the manufacturer.
Information in this document is subject to change without notice and the manufacturer shall not be
liable for any direct, indirect, special, incidental or consequential damages in connection with the
use of this material.
All trademark and trade names mentioned in this document are acknowledged to be the property of
their respective owners.
Disclaimer
While every precaution has been taken in the preparation of this manual, the manufacturer assumes
no responsibility for errors or omissions. Neither does the manufacturer assume any liability for
damages resulting from the use of the information contained herein. The manufacturer reserves the
right to change the specifications, functions, or circuitry of the product without notice.
The manufacturer cannot accept liability for damage due to misuse of the product or due to any other
circumstances outside the manufacturer’s control (whether environmental or installation related).
The manufacturer shall not be responsible for any loss, damage, or injury arising directly, indirectly,
or consequently from the use of this product.
Cautions and Notes
The following symbols are used in this guide:
CAUTION. This indicates an important operating instruction that
should be followed to avoid any potential damage to hardware or
property, loss of data, or personal injury.
NOTE. This indicates important information to help you make the best use of this
product.
Safety Precautions and Installation Guidelines
To ensure reliable and safe long-term operation, please note the following installation guidelines:
•
Only use in dry, indoor environments.
•
The Converter unit and power supply can get warm. Do not locate them in an enclosed space
without any airflow.
•
Do not place a power supply directly on top of a unit.
•
Do not obstruct a unit’s ventilation existing holes.
To safeguard against personal injury and avoid possible damage
to equipment or property, please observe the following:
•
Only use power supplies originally supplied with the product
or manufacturer-approved replacements. Do not attempt to
dismantle or repair any power supply. Do not use a power
supply if it appears to be defective or has a damaged case.
•
Connect all power supplies to grounded outlets. In each case,
ensure that the ground connection is maintained from the
outlet socket through to the power supply’s AC power input.
•
Do not attempt to modify or repair this product.
EUROPEAN UNION DECLARATION OF CONFORMITY
This is to certify that, when installed and used according to the instructions in this manual,
together with the specified cables and the maximum cable length <3m, the Units:
AC1038A
are shielded against the generation of radio interferences in accordance with the application of
Council Directive 89/336/EEC as well as these standards:
EN 55022
:
1999
Class A
EN 55024
:
1999
IEC 61000-4-2:
2001
IEC 61000-4-3:
2001
IEC 61000-4-4:
2001
EN 61000-3-2
2001
EN 61000-3-3
2002
The device was tested in a typical configuration with PC.
This equipment has been found to comply with the limits for a Class A digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference when the equipment is operated in a commercial
environment. This equipment generates, uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the instruction manual, may cause harmful
interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Contacting Black Box Technical Support
Country
Web Site/E-Mail
Phone
Fax
US
www.blackbox.com
724-746-5500
724-746-0746
Germany
www.black-box.de
+49 811 5541 110
+49 811 5541 499
Shipping and Packaging
If you need to transport or ship your DVI2VGA Converter:
•
Package it carefully. We recommend that you use the original container.
•
If you are shipping it for repair, please include the Unit’s external power supply. If you are
returning it, please include everything you received with it. Before you ship the Converter back
to your dealer for repair or return, contact him to get a Return Authorization (RA) number.
DVI-D to VGA Converter
(DVI-Singlelink)
AC1038A
(manual)
http://www.blackbox.com
Black Box Network Services -
The world’s largest network services company
We are, with 25 years of experience, the world leader in network infrastructure services.
