background image

8

1

Distributed by:  

Directed Electronics  

Address:  

44 Translink Drive, Keilor Park Victoria Australia 3042 

PH: 

 + 61 03 8331 4800 

Email:  

[email protected]

Baccus Worldwide LLC 

Weena 290, 3012 NJ Rotterdam or 

Postbus 819, 3000 AV Rotterdam 

+31(0)10 282 16 11

 

Cat. # BDPC400AU 

September 2016 

RD091216 

Printed in China

500 WATT POWER INVERTER 

WITH USB CHARGING PORT 

INSTRUCTION MANUAL

BDPC400AU_Manual_091216.indd   8-1

9/12/2016   11:55:45 AM

Summary of Contents for BDPC400AU

Page 1: ...8331 4800 Email service directed com au Baccus Worldwide LLC Weena 290 3012 NJ Rotterdam or Postbus 819 3000 AV Rotterdam 31 0 10 282 16 11 Cat BDPC400AU September 2016 RD091216 Printed in China 500WATT POWER INVERTER WITH USB CHARGING PORT INSTRUCTION MANUAL BDPC400AU_Manual_091216 indd 8 1 9 12 2016 11 55 45 AM ...

Page 2: ...anges in speed or direction The appliance should be protected from direct sunlight heat and moisture Inspection and repairs Before use check the appliance for damaged or defective parts Check for breakage of parts damage to switches and any other conditions that may affect its operation Do not use the appliance if any part is damaged or defective Have any damaged or defective parts repaired or rep...

Page 3: ...utputs up to 100 Watts only The tip of the plug is positive and the side contact is negative Warning Make sure that the On Off button is turned off 0 and that no flammable fumes are present in the installation area before connecting the accessory plug to the accessory outlet Warning Connect the ring terminals to the terminals of the power inverter before connecting the accessory plug to the access...

Page 4: ... If the inverter on off switch has been pressed to turn the unit on but there is no mains or USB power output and the power fault LED flashes then one of the following conditions has occurred Low battery voltage Over voltage Short circuit Overload Over temperature Press the on off switch to turn the inverter off correct the fault and then press the on off switch again to turn the inverter back on ...

Reviews: