15
E N G L I S H
Fitting
Remove the guard as described above.
Place the inner flange (12) onto the spindle (9)
as shown (fig. H). Make sure that the flange is
correctly located on the flat sides of the spindle.
Place the backing pad (16) onto the spindle.
Place the sanding disc (17) onto the backing
pad.
Place the outer flange (14) onto the spindle
with the raised centre facing away from the disc.
Keep the spindle lock (3) depressed and tighten
the outer flange using the two-pin spanner (15)
(fig. A & I). Make sure that the outer flange is
fitted correctly and that the disc is clamped
tightly.
Removing
Keep the spindle lock (3) depressed and
loosen the outer flange (14) using the two-pin
spanner (15) (fig. A & I).
Remove the outer flange (14), the sanding disc
(17) and the backing pad (16).
After sanding, refit the guard on the tool.
USE
Let the tool work at its own pace.
Do not overload.
Carefully guide the cable in order to avoid
accidentally cutting it.
Be prepared for a stream of sparks when the
grinding or cutting disc touches the workpiece.
Always position the tool in such a way that the
guard provides optimum protection from the
grinding or cutting disc.
Wear safety glasses or goggles when
operating this tool.
Switching on and off (fig. J)
To switch on, slide the on/off switch (1)
forward. Note that the tool will continue
running when you release the switch.
To switch off, press the rear part of the on/off
switch.
Hints for optimum use
Firmly hold the tool with one hand around the
side handle and the other hand around the
motor housing (fig. K).
When grinding, always maintain an angle of
approx. 15° between the disc and the workpiece
surface (fig. L).
MAINTENANCE
Your Black & Decker tool has been designed to
operate over a long period of time with a
minimum of maintenance. Continuous satisfactory
operation depends upon proper tool care and
regular cleaning.
Before performing any maintenance,
switch off and unplug the tool.
Regularly clean the ventilation slots in your tool
using a soft brush or dry cloth.
Regularly clean the motor housing using a
damp cloth. Do not use any abrasive or
solvent-based cleaner.
You can check the location of your nearest
authorized repair agent by contacting your local
Black & Decker office at the address indicated in
this manual.
Technical data
KG915
Voltage AR, B2, B2C
220V
Voltage B3, BR
120V/127V
Power input
W 900
No-load speed
min
-1
10,000
Disc diameter
mm 115
Disc bore
mm 2
5/8"-11 / M14
e
zi
s
e
l
d
n
i
p
S
1
.
2
g
k
t
h
g
i
e
W
