BK Precision XLN10014, User Manual

Page: 181 / 207

85
4.7
Multi-Unit Programming Commands
The multi-unit programming commands used by the power supply
include a carriage return (CR) character for termination of all ASCII strings.
For all configuration commands (except for commands listed under
Synchronous Control Commands section), the instrument will return a
string “
OK
” to indicate command sent successfully. If an error
occurs, it will return an error. See the “
Error! Reference source not
found.
” section for details.
4.7.1 System Control Commands
This set of commands is used to select the instrument (based on their
address) to control and to obtain/set its system settings.
Command Description
==================================================
CADR Selects the address, which can be 1 to 30, of the power
supply to access and control.
CCLS Clear status
CRST Reset command. Brings the power supply to a
known state
CIDN? Returns the power supply model identification
CREV? Returns the firmware version
CSN? Returns the serial number
CST? Returns the device status
CCLR? Clear protect
==================================================
CADR
Note:
This command must be used first prior to any other