BK Precision 4060B Series, Programming Manual

Page: 11 / 28

Common Command Introduction 11
C1:BSWV WVTP, SINE,FRQ,100HZ,PERI,0.01S,AMP,2V, OFST,0V,HLEV,1V,LLEV,-1V,PHSE,0
Set noise bandwidth value of channel one to 100MHz
C1:BSWV BANDWIDTH, 100000000
2.14 Modulate Wave Command
Description Sets or gets modulation parameters.
Command <channel>:MoDulateWaVe<parameter>
Syntax <channel>={C1, C2}
<parameter>={a parameter from the table below}
2.14.1 ParamtersTable
Parameters Value Description
STATE <state> Turn on or off modulation. Note: if you want
to set or read other parameters of modulation,
you must set STATE to ON at first.
AM, SRC <src> AM signal source.
AM, MDSP <mod wave shape> AM modulation wave. Only when AM sign al
source is set to INT, you can set the
parameter.
AM, FRQ <AM frequency> AM frequency. Only when AM signal sour ce
is set to INT, you can set the paramet er.
AM, DEPTH <depth> AM depth. Only when AM signal source is set
to INT, you can set the parameter.
DSBAM, SRC <src> DSBAM signal source.
DSBAM, MDSP <mod wave shape> DSBAM modulation wave. Only when AM
signal source is set to INT, you can set the
parameter.
DSBAM, FRQ <DSB-AM>< frequency> DSBAM frequency. Only when AM signal
source is set to INT, you can set the
parameter.
FM, SRC <src> FM signal source.
FM, MDSP <mod wave shape> FM modulation wave. Only when FM signal
source is set to INT, you can set the
parameter.
FM, FRQ <FM frequency> FM frequency. Only when FM signal source is
set to INT, you can set the parameter.
FM, DEVI <FM frequency deviation > FM frequency deviation. Only when FM
signal source is set to INT. you can set the
parameter.
PM, SRC, <src> PM signal source.