Save and Recall
115
Load the specified type of file in the external USB storage device.
1. Press the
Save/Recall
key on the front panel to enter the SAVE/RECALL function menu.
2. Press the
Recal
l softkey to enter the RECALL menu.
3. Press the
Type
softkey to select
Setup
or
Waveform
.
4. Press the
Recall
from softkey to select External.
5. Press the
Press To Recall
softkey to enter the SAVE/RECALL file system.
6. Turn the
Universal Knob
to select the file to be recalled, press the
Press To Recall
softkey to recall the waveform
or setup.
13.4 Disk Management
Disk management aim at the save and recall operations after the oscilloscope is connected with a USB storage device.
Before using an external disk, make sure that the USB storage device is connected correctly.
13.4.1 Create a New File or Folder
This operation is only valid in external storage. The oscilloscope supports English input method. The file name or folder
name can contain letters, numbers, underscores and spaces.
Example
Create a file or folder named “CSV”
1. Press the
Save/Recall
key on the front to enter the SAVE/RECALL function menu.
2. Press the
Save
softkey, and then turn the Universal Knob to select one of the type (if select
Setups, please set the Save To option to External).
3. Press the
Press to Save
softkey to enter the SAVE/RECAL file system.
4. Press the
New
softkey to open the interface shown as the picture below. It divides into two
parts: name input area and keyboard area.
Figure 13.4
Input Keyboard
5. To delete the name in the name input area, press the
Backspace
softkey continuously to delete
the character one by one.
Summary of Contents for 2194
Page 1: ......
Page 82: ...Serial Trigger and Decode 82 Figure 7 29 LIN Trigger ...
