Measure
102
9.
FFLF:
Time from the first falling edge of channel A to the last falling edge of channel B.
10.
Skew
Time of source A edge minus time of nearest source B edge.
11.2 Automatic Measurement
Perform the steps below and select voltage or time parameters to make automatic measurement.
1. Press the
Measure
key on the front panel to enter the MEASURE function menu. At the same, the frequency and
period are enabled with the current trigger channel, the statistics also was enabled.
2. Press the
Source
softkey, and then use the
Universal Knob
to select the desired channel. Only analog channels that
are displayed are available for measurements.
3. To select and display measurement parameters. Press the
Type
softkey, and then turn the
Universal Knob
to select
the desired measurement parameter.
4. Press the
Universal Knob
to add the measurement parameter, the parameters and value will be shown above the
menu, and the statistics status will update.
5. To turn off the statistic function, press the
Statistics
softkey to select
Off
.
The measurement display area can display 4 measurement parameters at most, and the measurements will arrange
according to the selecting order. If a fifth measurement is added, the first measurement will be deleted.
Figure 11.5
Measurement Type
Summary of Contents for 2194
Page 1: ......
Page 82: ...Serial Trigger and Decode 82 Figure 7 29 LIN Trigger ...
