P a g e
|
51
XXPRESS® NGX USER MANUAL
– XP-5001-01-5
Figure 19
1. Remove the AC plug from
the power inlet module
2. Use a small flat bladed
screwdriver to carefully
pull out the fuse holder
3. Fit the correct fuse in the
far position only
4. Push the holder back into
the inlet mode
8.2 Routine Cleaning and Inspection
The unit casework should be cleaned and inspected at regulator internals,
and whenever contamination or spillage occurs, as follows:
1. Switch off the unit and disconnect the power before performing
any inspection checks or cleaning.
2. Before cleaning, always inspect the unit casework, heater plate
and moving parts for any signs of wear, damage, cracks or other
defects.
3. Clean the casework using a damp cloth soaked with a
disinfectant solution (such as Virkon), whilst wearing suitable
PPE.
4. Remove any debris or fluff from around or between the moving
parts of the door mechanism and sliding plate carrier.
5. Clean the display and buttons, taking care to avoid over wetting.
6. Check that the ventilation holes underneath and on the rear of
the unit are clear of dust and fluff build-up. Replace the air filter
as necessary.
DANGER
After cleaning, ensure that the unit is thoroughly dry, especially
around the mains power inlet, before reconnecting the power
cord and switching the unit on.
Summary of Contents for XXPRESS NGx
Page 56: ......