BJ-232
BJ Enabler 1R-LV
User’s guide
This Enabler with one relay switched
contact and powered with low voltage, is
designed to activate elements such as
motored doors, one-light circuit, a
warning, the doorbell, etc.
Fig. 1: BJ Enabler 1R-LV
You can activate the Enabler remotely
using any of the BJ System’s remote
controllers or directly via special
switches.
RF Frequency
: 433MHz
Power supply
: 12-24Vdc / 12Vac
Output
: 1 COM relay contact
Section of the power cables
: 1,5mm
2
Maximum section in load circuit
:
2,5mm
2
Dimensions:
50x50x25mm
Maximum loads
:
•
Resistive loads (light, bulbs,
halogen lamps…): 12A
•
Inductive loads:
3.5A/350W/cos
ϕ
=0,4.
For correct installation, the Enabler must
be fitted in a sealed box that provides
sufficient space, absence of dust and
humidity and isolation from direct
contact with people.
To install the Enabler you must carry the
Enabler’s power cable, load cable and
switch’s cable to the box where it will be
installed.
For a proper installation of the device
see figure 2:
IMPORTANT:
See the device
technical data to check the type and
maximum loads that can be
connected to the Enabler. Power
cables must be stripped a distance
of 6mm.
Once the Enabler’s connections are
made and before connecting the device
to the power supply, you must choose
the position on the “RF code selector”
(see figure 1).
To control the load via an alternative
access switch, connect the two cables of
the switch to the Control input.
This Enabler is designed for switching
devices in two selectable operating
modes:
12/24Vdc
Control
12 Vac
C
NA
NC
Relay output
input
RF code
Mode
operating
selector
jumper
External switch
load control
Power supply
2. Technical data
3. Pre-installation
1. Description of the device
4. Installation
5. Operating modes
Power
Supply
input
CAUTION!
Electrical installation may only
be carried out by a qualified
electrician!
Do not make any unauthorized
alterations or modifications to the
unit.
The relay contact is only suitable
for
low voltage power supply
(12-24 V dc/ 12V ac)
Observe the manufacturer’s
instructions for the device to be
operated.
CAUTION!
An error in the connections may
cause serious damage to the
device or the installation, or
harm to the operator.
Operating mode
jumper JP1
(back side)
RF Code
selector
(back side)
Switch control
input
Relay
output
