BizLink RM-826-Q25-WD, User Manual, Page: 9 / 48

Ethernet Ports
Connect computers/devices using an Ethernet cable
WAN Port
Connect to a modem from Internet Service Providerusing an Ethernet
cable
Reset
Press for 10 seconds to reset to the Factory Default.
Power
Use provided 12V 1.0A Power Adapter
Installing the Bizlink Router
The BizLink router can be used as either as a regular high-speed router connected to your
cable/DSL/Satellite connector, or as a 3G/4G/LTE/LTE2 router, or both.
Using a Ethernet, DSL or Cable Modem or Satellite Modem
Make sure you have the following:
DSL or cable modem or Satellite modem
Active Internet Account
Then,
1. Connect your DSL, Cable or Satellite modem to the router’s WAN port using an Ethernet
cable.
2. Connect the power cable to the router’s power jack and plug it in to the wall socket.
3. Connect your PC to any of available Ethernet port using an Ethernet cable or connect via
wireless (WIFI)
Using a SIM card from your Cellular Carrier
1. Insert your SIM card in the SIM card slot on the side of the router. TIP: foil side UP, wedge
IN. Connect all 4 antennas to router.
2. Connect the power cable to the router’s power jack and plug it in to the wall socket.
3. Connect your PC to any available Ethernet port using an Ethernet cable or connect via
wireless.
(do not use the WAN)
4. If your router was sent pre-programmed by your carrier then you should be connected. If not,
you will need access the router and manually insert the APN (Access Point Name) for your
carrier. See Setting APN below.
Note the gold portion of the sim card is facing upwards and slot side in first.