Bizerba GLM-I, Instruction Manual, Page: 85 / 505

Instruction manual GLM-I Display and operating unit
38.019.129.001 en 83
7
7.7.4 Printing table data
The data of a table editor can be printed for controlling or archiving purposes on blank la-
bels, ticket rolls or lists.
To make available the keys that are necessary to release the print,
make sure the additional keys at the bottom frame edge are shown
be-
fore opening the table, see page 66.
Minimum width of empty labels or ticket rolls used: Standard printing of editor data re-
quires empty labels or ticket rolls with a width of 68 mm. Blank labels and ticket rolls with a
width of 58 mm can only be used when setting a smaller character set.
Please contact your Bizerba consultant or Bizerba Service for further in-
formation.
Preparing printing on blank labels
To avoid that the labels need to be removed constantly, cut off backing paper under-
neath the printer before starting printing and lead it out of device.
After the final label was printed, cut off the backing paper and remove the label strip
as an entire piece.
Then, properly insert backing paper again into printer and take-up unit.
Preparing printing on ticket roll
Mode level: 2
Insert a ticket roll into the labeler instead of backing paper.
<Labels> / <Printer menu> / <Etc> / <Print out- put to ...>
Select and confirm "Ticket w/o preprHead".
After printing insert backing paper again into labeler and re-establish
the previous setting of print output (standard setting: "Lab.w. backing
paper").