Bizerba GLM-I, Instruction Manual, Page: 226 / 505

Codes and scanning rules Instruction manual GLM-I
224 38.019.129.001 en
19
19.3.6 Special inputs
Depending on the code type, different settings can be made via the softkey
<Special inputs>.
Special input field Description
"Horizontal bar" Switch the bars over the barcode on or off.
"LeftBrightZone", "Right-
BrightZone"
Switch on or off left or right light area. If the left or right light
zone on the label is already available, the width of the code
field can be reduced and set as having no light zone. This on-
ly makes sense for customer labels. By standard, each code
is set to have a left and right light zone.
"Plain writing" Switch on or off plain writing below the barcode. Switch on
optical characters for trading codes.
"13th digit" EAN13 code:
Print position for 13th digit
x||...:
left, next to code
||x...: left, under the code
"Check digit" Code128, Code2/5 int. and Code39:
Switch check digit on or off.
"Prefixed 0" UPC-A-Code:
Switch 0 prefixed to the barcode either on or off.
"Symbol height" EAN-D3-Code in block 2 and 6:
Set symbol height.
"one":
uniform code height
"two": Print characters 1-12 20 % smaller
"Symbol vertical" EAN-D3-Code in block 2 and 6:
Swap the sequence.
"W/o":
normal order
"With": Print characters 13-24 in front of
characters 1-12
"Line break" EAN-D3-Code in block 2 and 6:
Set page break.
"W/o":
Print w/o page break
"With": Print characters 1-12 in level 1,
and characters 13-24 underneath
"Number of columns" PDF417 code:
Enter maximum number of columns (1-30 columns).
If 0 is prespecified, the number of columns is automatically
adjusted to the code.