BIXOLON XT2-40 Series, User Manual, Page: 51 / 57

Ver. 1.00 - 51 -
XT2-40 Series
5-4 Cleaning Auto Cutter (optional)
1) Open the media cover and print head levers and remove the media and ribbon.
2) Please refer ‘3-9 Auto Cutter Module Installation’ and remove the Auto Cutter Module.
3) Remove 2 screws on both side and remove the cutter cover.
4) After exposing the cutter blade completely by rotating the knob, remove dust or foreign
substances using a cotton swab dipped in medical alcohol solution.
(Use (+) Screw Driver to adjust the knob.)
5) Allow 1~2 Minutes for the alcohol to evaporate and reassemble the module.
Caution
- Be sure to clean after turning the printer off.
- Be careful not to scratch the cutter blade.
The printer may be damaged.
Warning
Do not touch cutter edge of auto cutter when cleaning.
This can cause serious bodily injury.
Cutter Blade
Knob
Screw
Cutter Cover