Page 15 of 191
800581-2.11 NeurOne System User Manual.doc
2.5 Maintenance and Service
Please follow the maintenance and calibration instructions. You should inspect the
system devices and cables regularly. If there is visible damage, it is best to have it
repaired at your local distributor or Bittium Biosignals Ltd.
2.5.1 Cleaning
You can clean the device using a non-fluffing cloth dampened in cleaning fluid, such as
water and mild hand soap solution. For accessories, like EEG cap, follow the
instructions provided with the accessory.
Disconnect the power supply before cleaning. Be careful not to rub too
forcefully. Do not use alcohol based fluids or corrosive chemicals! Do
not sink the device or cables into the cleaning fluid!
2.5.2 Calibration
The equipment is calibrated at the factory and it does not require regular calibration.
Do not try to open the device, the Power Supply, the cables or other
sealed parts of the system. Only technical personnel, authorized by
Bittium Biosignals Ltd, are allowed to open these parts, subject to the
instructions given by Bittium Biosignals.
2.6 Disposal and Environmental Issues
The packaging material is cardboard. It can be re-cycled according to local regulations.
When the device is not used, consider disconnecting it from the mains current. Note
also that when the device is used according to instructions the service need for the
device is minimized and the life time of the device is optimized.
Please follow your local environment safety regulations when disposing of the system,
or any parts of it. In many countries the electronics re-cycling is possible or even
obligatory.
For EU only: This symbol indicates that this device shall be disposed according
to European Union directive 2002/96/EC on Waste Electrical and Electronic
Equipment (WEEE). If the device is contaminated the directive does not apply.
