11
www.bitrek.com.ua
sales@bitrek.com.ua
+380 44 507 02 07
Setting of the device through any of the available methods is limited
with the setting of the required values of the device parameters. Each
parameter has its own unique ID. Special commands are used to read/record
the values of selected parameter.
At remote configuration via SMS take into consideration that the total
length of the SMS shall not exceed 160 Latin characters. Number of
commands in SMS is limited to a maximum length of SMS.
All commands for the device are divided into control and information
commands.
List of information commands to operate the device
Table 3 - List of information commands to operate the device "BI-520L
TREK"
No. Command
Description
Availability
of response
1
getstatus
Information about current state of the
device
Yes
2
getgps
Current GPS coordinates and time of
device.
Yes
3
getmap
Request of device coordinates
Yes
4
getver
Request of the version of the device
software
Yes
5
getio
Read the value of the device's internal
sensors
Yes
6
flush
Request of device profile parameters
Yes
7
getparam
####
Read the value of the parameter by its ID
Yes
Notes to Table 3
Information about current state of the device.
Command to be sent -
getstatus
;
Example of response: «Data Link: 1 GPRS: 1 IP: xxx.xxx.xxx.xxx GSM: 4
Roaming: 0», where:
Data link - current state of connection
(0 - not connected to server, 1 - connected to server);
GPRS - status GPRS (0 - not active, 1 - active);
IP - IP address of the device with an active GPRS connection; it is assigned by
the operator (not to be confused with the IP address of the server);
GSM - level of GSM signal (1 - minimum, 5 - maximum);
Roaming - SIM-card in roaming (0 - home network, 1 - roaming).