11
Unplug the cleaner from electrical outlet.
The Upper Tank Filter can be reached by removing the Dirt
Container, reaching underneath the Upper Tank and turning
the rim of the Filter Frame to unlock. Pull straight down to
remove. Brush the dirt off the Louvers and Upper Tank Filter.
The foam Upper Tank Filter may be removed and hand
washed in cold water with mild detergent. Rinse well then
air dry thoroughly before replacing.
The Upper Tank and Louvers may also be wiped clean with
a damp cloth.
Note: For easier access, the entire Upper Tank
may be removed by turning the knob on the
back of the cleaner to unlock and pulling the
entire tank straight out.
Unplug the cleaner from electrical outlet.
The Pre-Motor Filter protects the motor from dirt particles.
It is located in the slide out tray underneath the Dirt
Container. If the filter becomes dirty, pull out the tray, lift
out the filter and clean.
The Post-Motor Filter assists in the filtration process to
return clean air to the room. It is located behind the door on
the side of the cleaner. If the filter becomes dirty, open the
door, remove the filter and clean.
Note: Select Models come with a white, pleated
HEPA Media Filter. This filter is not washable
and must be replaced.
The standard filters may be hand washed in cold water
with mild detergent. Rinse well and air dry thoroughly
before replacing.
You should check your vacuum cleaner’s Rotating
Floor Brush and Drive Belt regularly for wear or
damage. You should also clean the brush and brush
ends of strings, hair, and carpet fibers. These can
wrap around the brush and hamper its ability to
effectively clean your carpet. Also remove any debris
that has accumulated under the brush cover.
Unplug cleaner from electrical outlet.
Place handle in Low position and turn vacuum cleaner over
so bottom side is up.
Wide Power Trak foot
, remove the five screws as shown
with a Screwdriver. Lift the Brush Cover off.
Wide Cleaning Path foot
, lift Tab 1 and release the three
latches in order 2-4 marked. Lift the Brush Cover off.
1.
Check Rotating Floor Brush and Drive Belt
2.
Cleaning The Pre-Motor and Post-Motor Filter
Cleaning The Upper Tank & Filter
WARNING:
To reduce the risk of injury
from moving parts, turn
off vacuum cleaner and
disconnect Power Plug
from electrical outlet.
Post-Motor
Filter
Pre-Motor
Filter
WARNING:
Do Not operate cleaner
with damp or wet
filters or without all
filters in place.
1.
2.
3.
4.
1.
2.
3.
4.
3.
4
Wide Cleaning Path foot
Wide Power
Trak foot
