To maximize your
cleaning performance
and
extend the
life
of your vacuum, it is very important that you empty
your dirt container and check and clean your filters fre-
quently. Perform the following maintenance steps:
Empty the Dirt Container when the dirt reaches the “Full”
line on the side.
Check the Upper Tank and Pre-Motor Filters at least once a
month and clean or replace as needed.
Clean or replace the Post-Motor Filter every three to six months.
Note: More frequent filter cleaning may be
necessary if you are vacuuming new carpet,
fine dust, or have allergy concerns. Follow the
instructions on the following pages to perform
these simple maintenance steps.
The Dirt Container needs to be emptied when the dirt
reaches the “Full” line on the side of the Container.
Unplug cleaner from electrical outlet.
Slide the Lock ‘n Seal Lever to the "Unlock" position.
Grasp handle and pull the Dirt Container straight out to
remove from vacuum.
Empty dirt into garbage container.
Put the Dirt Container back in the vacuum and slide the
lever to the "Lock" position.
Note: The Dirt Container may be washed in
warm water with a mild detergent. Make sure it
is completely dry before using again.
To maintain the effectiveness of the Clean Carpet
Sensor, a quarterly cleaning of the internal sensor
lens is recommended. To clean the sensor lens,
detach the Twist ‘n Snap Hose and
gently
wipe the
clear lens area using a lightly dampened
soft
cloth.
Allow enough time for the lens to dry thoroughly
before reattaching the Twist ‘n Snap Hose and using
the vacuum.
10
Clean Carpet Sensor
How To Maintain Your Vacuum
1.
2.
3.
Empty Dirt Container
1.
2.
3.
4.
5.
Full Line
Lock Position
Unlock
Position
Tip:
For maximum cleaning
performance, check
and clean or replace all
filters as suggested.
WARNING:
To reduce the risk of
electric shock, turn
Power Switch OFF and
disconnect polarized
plug from electrical outlet
before performing
maintenance or
troubleshooting checks.
