SignalHawk™ PC and Rack Mount Models
79
Updating the Firmware
Note:
There are two different firmware files: one containing the
DSP image and the other containing the FPGA image.
1.
Navigate to Bird Technologies Group>PC SignalHawk in the Start menu.
2.
Click on Firmware Update Wizard.
Note:
The wizard will launch and provide step-by-step
instructions.
3.
Select the DSP and FPGA images to be updated.
Figure
68
DSP and FPGA Image Selection
4.
Connect the unit to the PC via USB cable.
5.
Turn on the SignalHawk.
6.
Select “Install the software automatically...” if the “Found New Hardware
Wizard” is presented.
Note:
Both program wizards will run co-currently. See
the SignalHawk Program" on page 9
for the PC SignalHawk.
7.
Click “Next.”
Figure
69
DSP List
Summary of Contents for SignalHawk SH-36S-PC
