PRIOR TO INSTALLATION
Your complete Bird Gard
®
Pro kit includes a con trol unit
with built-in speaker, mount-
ing bracket and AC power
adapter. (An optional battery
clip assembly is available;
an optional speaker may be
plugged into the speaker jack
on the back of the unit.)
IMPOR TANT:
Be certain that the power switch is in
the
OFF
po si tion and the volume control is set to the
minimum
(LOW)
vol ume level ( coun ter clock wise) as
shown in
Fig. 1
when powering up the unit.
SETUP AND INSTALLATION
1) It is recommended to mount the
unit on a post or surface that
is positioned in the direction
and at the same level of the
infected area.
2) Use the included metal mounting bracket
(Fig. 2)
and screws (2) with lock washers (2) to mount the
unit to a post, fence, wall or other surface.
3) Open the clear front panel in order to set the
Recording Switches, Mode Setting Switches,
Time Off Switches, Time of Operation Switches
and Random Operation Switch to the desired
settings. (See “
PROGRAMMING YOUR BIRD
GARD
®
PRO
” for more programming details.)
Digital Bird Repeller
VOLUME CONTROL
The unit has a volume control dial on the front panel
of the unit
(Fig. 1)
. Turn the dial toward
LOW
to
reduce
sound output and rotating the dial toward
HIGH
increases sound output (
VOLUME
).
CAUTION:
Take care when turning the dial since the unit may be
in an inactive state when the dial is rotated. It could then re ac ti vate
at a very high level of sound which could be painful to your ears.
POWER SWITCH
The power switch enables the unit to operate.
Slide the switch to the ON position to start the unit.
If you turn the unit OFF, be sure to leave it off for
about 30 seconds before turning it back on to allow
the electronics to properly reset.
TROUBLESHOOTING
PROBLEM
Unit is on, but
no sound is heard
Unit is on, but plays the
same bird over and over,
regardless of settings
Unit is
not
operating
properly in the
DAY or NIGHT mode
Unit does
not
function
properly when connected
to a 12-volt battery (when
using optional battery clip
assembly)
• Check volume settings.
• Check time of operation settings.
• Check that at least one bird is
selected to play.
• Reset the unit by turning it
off for 30 seconds and then
back on.
• Double check Mode
switch settings.
• Make sure photocell
is not obstructed.
• Make sure the photocell is
not affected by bright lights
in either the front or the
back of the unit.
• Check battery condition.
• Turn power switch on unit
to the OFF position. Then
reconnect the battery, wait
30 seconds, then switch the
unit back on.
SOLUTION
Fig. 1
Bird Gard Pro Instructions P/N 655-0051-00 (Rev. G)
©2015 Bird Gard, LLC. All Rights Reserved
Bird Gard
®
is a patented trademark of Bird Gard, LLC.
EPA Establishment Number 075130-OR-001
LIMITED WARRANTY
IF YOU ARE NOT COMPLETELY SATISFIED, CONTACT THE PLACE
OF PURCHASE OR OUR
CUSTOMER SERVICE DEPARTMENT
WITHIN 1 YEAR OF YOUR DATE OF PURCHASE FOR PROMPT AND
COURTEOUS REPLACEMENT, REPAIR OR REFUND.
BIRD GARD LLC'S LIABILITY HEREUNDER SHALL BE LIMITED
TO REFUNDING THE PURCHASE PRICE PAID BY CUSTOMER OR
REPLACING THE PRODUCT, IN BIRD GARD'S SOLE DISCRETION,
AND UNDER NO CIRCUMSTANCES SHALL BIRD GARD BE LIABLE
FOR ANY CONSEQUENTIAL OR INCIDENTAL DAMAGES, OF ANY
NATURE WHATSOEVER, ARISING FROM THE CUSTOMER'S USE OR
OPERATION OF THE PRODUCT; PROVIDED, HOWEVER, THAT THIS
LIMITATION MAY BE LIMITED BY STATE LAW.
EXCEPT FOR THE EXPRESS ONE-YEAR LIMITED WARRANTY
SPECIFICALLY DESCRIBED HEREIN, BIRD GARD DISCLAIMS
ALL OTHER WARRANTIES, EXPRESS OR IMPLIED, RELATING TO
THE PRODUCT, INCLUDING, BUT NOT LIMITED TO, ANY IMPLIED
WARRANTY OF MERCHANTABILITY OR IMPLIED WARRANTY OF
FITNESS; AND THE EXPRESS WARRANTIES ARE IN LIEU OF
ALL OBLIGATIONS OR LIABILITIES ON THE PART OF BIRD GARD
ARISING OUT OF OR IN CONNECTION WITH THE SALE, USE, OR
OPERATION OF THE PRODUCT.
P.O. Box 1690 • 270 East Sun Ranch Drive
Sisters, Oregon 97759 • U.S.A.
1-888-332-2328 • Fax 541-549-5286
[email protected] • www.birdgard.com
Fig. 2
Extension
Speaker
Power
