1
XRF-TI
LED
2x
18
194
174
190
4.5
4.5
18
Transmitter for wireless signal transmission system for safety edges
Supplementary sheet to the original operating instructions
Intended use: Monitoring safety edges on doors and gates, in combination with the XRF-Rx receiver
ENGLISH
404301C
07/20
Carefully pull out
the PCB
Loosen screw
Plug in connector
Pairing is possible with open transmitter or later in mounted situation.
After initiating pairing on Rx:
Press button
(see receiver manual)
After initiating pairing on Rx,
press the edge two times within 2 sec.
Pairing (1.2) if required
Slide in the PCB again
Close the housing, tighten the screw
LED flashes 5x (confirms battery connected)
Delivery state
Battery connected
1.1 Connect battery
1.2.a
Pairing at open state
1.2.b
Pairing at built-in state
1.2 Pairing
1
Set-up
Battery 3.6. V
Button
Screw
Button
Note:
Position of
red wire
Note:
Alignment of battery,
position of wire
PCB
Cable
with
plug
Wire
