BIQU BIQU-Hurakan, User Manual, Page: 17 / 62

17 / 62
WWW.BIQU3D.COM
4.5 Insert Filament
Cut the filament tip pointy, hold down the extruder handle,
and push the filament into the extruder into the filament
tube at the same time.
Note: Check whether the screws on the machine are
installed correctly, and make sure they are tight.
4.6 Tuning of Nozzle Height
Enter the secondary interface during printing:
Tune——Offset Z:0.000
Adjust according to the height of the nozzle. When the
nozzle is too high from the bed, Z is adjusted to a negative
number, and when the nozzle is too low or presses to the
bed, Z is adjusted to a positive number.