Start-up
Switching On and Off
8
CE mark
IP30
•
Protection against the ingress of solid foreign bodies with a ≥ 2.5 mm diameter
•
No protection against ingress of water
Regulatory compliance mark (RCM)
Connecting the Device
Prerequisite
•
The Renamic is equipped with a certificate for communication with BIOTRONIK.
•
No other DataBridge is connected to the Renamic.
•
The Renamic is not being used for an implantation or follow-up at the time of connecting it.
1.
Check that at least PSW software version 2201 or higher is installed on the Renamic. If an older
software is installed, you must update and install the latest software.
2.
Switch off the Renamic.
3.
Connect the USB connector of the device to the Renamic USB port.
4.
Switch on the Renamic.
Result
When the Renamic is ready for use after successful start-up, the DataBridge on/off light indicator turns
green. On the Renamic user interface, the number
[4]
is displayed in the status bar next to the symbol
for the signal strength of the mobile connection.
On/Off light indicator
The on/off light indicator is located on the top side of DataBridge. It is an open circle. The on/off light
indicator is only visible and continuously lit green when DataBridge is connected and the Renamic is
turned on.
Switching On and Off
The device does not have its own on/off key. When DataBridge is connected to the Renamic, it can only
be switched on or off by switching the Renamic on or off.
Switching on
1.
Switch on the Renamic.
Switching off
1.
Switch off the Renamic.
Or
Disconnect the USB connector of the device from the Renamic USB port.
