Biotek ELx808, Operator'S Manual

Page: 43 / 172

10: Install Software/Connect to Computer (Optional)
|
21
5. PROMPT SAMPLE COUNT allows the user to enter the total number of samples
on the plate at runtime; only those sample results will be printed. Select
YES to
present this prompt at run-time.
Read Speed
R E A D I N R A P I D M O D E ? N O
Y E S N O
RAPID MODE reads a 96-well plate at 6-second intervals with wavelengths higher
than 400 nm. Selecting NO means a plate with single-wavelength kinetic
measurements will be read in intervals less than 12 seconds (“Regular” or “Normal”
Mode). Specifications for these modes are outlined in
Chapter 1
.
10: Install Software/Connect to Computer
(Optional)
The ELx808 has serial (RS232) port located on back of the reader (see Figure 3 on page 15).
This port allows the reader to communicate with a computer using the BioTek Gen5
software. It also allows for upgrades to the ELx808 basecode (on-board) software.
Attach the Cable
•
Turn off the computer and the reader.
•
Connect the supplied serial cable to both machines.
Install Gen5 Software on the Host Computer
If applicable, install Gen5 on the host computer. There is a
certain sequence of events that
must be followed to ensure
that the software is properly installed and configured. Please
follow the instructions provided in
Gen5 Getting Started
Guide to install the software.
ELx808 Operator’s Manual