Biotechne ProteinSimple Peggy Sue, User Manual

Page: 33 / 88

Auxiliary Module page 29
Sally Sue and Peggy Sue User Guide
The Start Run Wizard in Compass for Simple Western will also check the fluid levels in each bottle. When a
full or empty status is detected, Compass will display an error in the Start Run Wizard :
If this happens, fill or empty each bottle using the procedures in the next section.
Removing and Installing Bottles
Bottles may be removed from the auxiliary module whenever Sally Sue or Peggy Sue are idle. To remove or
install the waste or water bottle, use the following procedure:
IMPORTANT
Don’t remove either bottle if Sally Sue or Peggy Sue are running, doing this may abort the run in
progress.
1. Remove the bottle by unscrewing it clockwise until it disengages from the manifold.
2. Pull the bottle down slowly until the sensor at the bottom of the bottle is clear.
3. Fill the water bottle to the base of its neck and empty the waste bottle as needed.