Biotage Isolera Four, User Manual

Page: 27 / 116

411829-L, Data Administration April 2012 Page 2-1
Chapter
2
Data Administration
(Data Administration Mode)
WARNING
Before performing any procedures in this chapter, please read and observe
the safety requirements in the “Isolera Installation and Safety” document
(P/N 411828). Failure to follow those requirements may result in personal
injury and/or equipment damage.
2.1 Log into the Data Administration Mode
You must log into the Data Administration mode to be able to administrate cartridge types,
methods, rack types, results, solvents, and user accounts.
1. If you are not at the main menu, press Main Menu in the right-hand panel.
2. Press Data Administration . All user accounts with system owner privilege are listed in the
Select User dialog.
3. Select your user name. If you have not been assigned a user name and/or system owner
privilege, please contact your system supervisor.
4. Press OK . If your account is password-protected, the Password dialog opens.
a. Enter your password using the keypad. For the purpose of security, password characters
appear as asterisks.
b. Press OK . If you have entered a valid password, the software is opened in the Data
Administration mode.
For more information about the software modes, see “Software Description” on page 1-7.
NOTE
The first time you log into the Data Administration mode, log in using the
user account “System Owner” and the password “1234”. Before you log
out, it is strongly recommended that the password is changed (see
“Administrate the User List” on page 2-9).
Figure 2-1. Log into the Data Administration Mode
(Isolera LS with Spektra License Shown)