Biostar T41-A7 - BIOS, Setup Manual, Page: 25 / 57

T41-A7
23
Notices:
Not all types of Intel CPU perform above overclock setting ideally; the difference will be based on the
selected CPU model.
B. Memory Integration Test (M.I.T.)
This function is under “Overclocking Navigator Engine” item.
MIT allows users to test memory compatibilities, and no extra devices or
software are needed.
Step 1
The default setting under this item is “Disabled”; the condition parameter should
be changed to “Enable” to proceed this test.
BIOS SETUP UTILITY
Main Advanced
PCIPnP Boot
Chipset T-Series
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Select Screen
Select Item
Go to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
WARNING: Setting wrong values in below sections
may cause system to malfunction.
=========== Automate OverClock System ===========
============ Manual OverClock System ============
OverClock Navigator [Normal]
> ALL Voltage Configuration
Configure DRAM Timing by SPD [Enabled]
Auto OverClock System [V6-Tech Engine]
Intel(R) SpeedStep(tm) tech [Enabled]
Ratio CMOS Setting [ x12.0]
CPU Frequency Setting [200]
PCIE Frequency Setting [100]
FSB(Bsel) To NorthBridge Latch [Auto]
DRAM Frequency [Auto]
Integrated Memory Test [Disabled]
Exit
Options
Disabled
Enabled
↓
BIOS SETUP UTILITY
Main Advanced PCIPnP Boot Chipset T-Series
vxx.xx (C)Copyright 1985-200x, American Megatrends, Inc.
Select Screen
Select Item
Go to Sub Screen
General Help
Save and Exit
Exit
Enter
F1
F10
ESC
WARNING: Setting wrong values in below sections
may cause system to malfunction.
=========== Automate OverClock System ===========
============ Manual OverClock System ============
OverClock Navigator [Normal]
> ALL Voltage Configuration
Configure DRAM Timing by SPD [Enabled]
Auto OverClock System [V6-Tech Engine]
Intel(R) SpeedStep(tm) tech [Enabled]
Ratio CMOS Setting [ x12.0]
CPU Frequency Setting [200]
PCIE Frequency Setting [100]
FSB(Bsel) To NorthBridge Latch [Auto]
DRAM Frequency [Auto]
Integrated Memory Test [Enabled]
Exit
Options
Disabled
Enabled
Step 2
Save and Exit from CMOS setup and reboot the system to activate this test.
Run this test for 5 minutes (minimum) to ensure the memory stability.
Step 3
When the process is done, change the setting back from “Enable” to “Disable”
to complete the test.