BIOS AP DVM06U3, User Manual

Page: 29 / 76

－
28
－
2.5.2 Parameter Confirmation
Sometimes you will need to read and confirm the setup of current parameters then you can press both
MODE and SELECT button on the front at the same time at Monitor mode. Firmware version will be
shown at the beginning and the parameter can be rolled over by pressing MODE button.
< Factory Default Setting > this is a convenient form for customer to record all parameters.
Parameter Default or Pre-set Notes
Firmware Firm ware is Ver. x.xxx Information only for reference
Vendor ID Vender ID is BIOS Information only for reference
Model No Product ID is DVM06U3 Information only for reference
Serial No Serial No ID xxxxxxxx Information only for reference
IP Address
192.168.50.210
Address Mask 255.255.255.0
RAID Mode
RAID MODE RAID-6
RAID-10 / RAID-6 / RAID-0 / RAID-3 / RAID-5
DRIVE Mode DRIVE MODE 6 3, 4, 5, 6*
Disk Size DISK size Test1GB/1TB /2TB/3TB/4TB/5TB/6TB/7TB/8TB
Recovery Wait
Time
0.1 Sec
0/ 0.1/1/10 Sec, 2Min/5 Min/10 Min/20 Min
System Patrol 30Days/Cycle 10S, 5S, 3S, 5/10/20 DAYS/CYCLE