Operation Quick Start
Bio-Fragment Analyzer:
Qsep
1
Document No.: F0016
Ver.: C-20190726
Page: 1/3
1. Ensure the SD card is properly plugged in the
socket (Fig. 1 and 2).
3. Plug the power cord (labeled
Qsep
1
)
*SD card needs to be plugged-in before power on.
The SD card CAN NOT be initialized with hot plugging.
4. Switch on
Qsep
1
, the LED lights (multiple color light)
(Fig. 3). Wait 25 seconds for the instrument and Wi-
Fi initialization, and the green LED will start flashing
(Fig. 4).
-
Check if the AP source is available from your Wi-Fi
network in the computer (Fig. 5).
-
Find the SSID named with
“Qsep1+instrument ID
(16 digits) ”
and click “Connect” (Fig. 6)
-
Enter the password:
The password will show in the sticker which is
behind the instrument. It is the same as the
middle
8 digits
of instrument serial number (same as SSID
name) by blinding the prefixal
“Qsep1” (Fig. 7).
2. Connect the air tube.
Fig. 2
Fig. 1
*The green flashing LED shows the instrument is
successfully ready for connection. If not, please
repeat the step 4.
Wi-Fi connection: follow the steps below to
connect with
Qsep
1
Fig. 5
*DO NOT switch on the instrument immediately
after powering off. Wait at least 5 seconds
Ethernet cable connection:
refer to step 5 on Page 2
Ethernet cable
Fig. 3
Fig. 4
Fig. 6
*If your computer can’t find the SSID
of
Qsep
1
,
please keep the distance between
Qsep
1
and the
computer within 10 meterS and try again from the
step 4.
*If you can not connect with
Qsep
1
-
Please check the wi-
fi IP assignment is “Automatic
(DHCP)”
-
Allow Q-Analyzer pass through firewall or turn off
the firewall
blue
green
00923718
Fig. 7
