![Bioprom MPT-AIR BIO PID Operation Manual Download Page 33](http://html1.mh-extra.com/html/bioprom/mpt-air-bio-pid/mpt-air-bio-pid_operation-manual_2754807033.webp)
33
7.4 STB Safety Thermostat
The manufacturer recommends installing STB SAFETY THERMOSTAT which
protects the boiler from overheating in case of uncontrolled temperature rise.
Using the adjusting spring you should install the thermostat on the tube with
outgoing hot water and make sure it fits tightly to the tube surface.
The condition for repetitive actuation of the thermostat is the temperature lower
80±5°C.
7.5 Technical Maintenance Procedure
When using the Controller, it is recommended to adhere to the following rules:
it is recommended to hook up the unit using the surge arrester;
it is recommended to clean up the boiler in accordance with the Boiler
Manual requirements;
it is necessary to keep the unit away from moist environment and make that
no water will go inside the unit;
it is recommended to wipe clean of dust, when required;
installation, operation and repair of the Controller shall be carried out in strict
compliance with all the rules described in the Operation Manual;
hookup, adjustment and technical maintenance of the Controller shall be
carried out by the qualified personnel that are familiar with the Controller configuration,
hookup diagram, НПАОП 40.1-1.21 and «Regulations for Operation of Consumer
Electrical Installations» (ПТЭ).
it is required to check the technical condition of wiring prior to start of the
heating season and inspect it from time to time; it is also required to check stability of
position of the Controller during its operation.
it is required to measure grounding effectiveness for the pump and fan.
7.6 Storage Instructions
The Controller shall be stored in closed heated premises in cardboard boxes
under the following conditions:
surrounding air temperature from 0 to 40°С.
relative air humidity of not more than 90% under temperature of 35°С.
There should be no dust, fumes of acid and alkaline as well as aggressive gases
in the premises air.
8 WARRANTY OBLIGATIONS
1. The life cycle for
AIR BIO PID
Temperature Controller determined by LTD
«Bioprom Company Kharkov» is not less than 10 years.