101
BM3Vet Pro
User’s Manual
Sampling method
Connecting the CAPNOSTAT® 5 CO
2
Sensor to the Host System
1. Insert the CAPNOSTAT 5 CO
2
Sensor connector into the receptacle of the host monitor as
shown in Figure 1.
2. Make sure the arrows on the connector are at the top of the connector and line up the two
keys of the connector with the receptacle and insert.
3. When unplugging the connector, grasp the connector body and pull it out to release the
locking device. Be careful not to pull the sensor cable out, as this may damage the equipment
Connect the Mainstream CO2 Sensor to the Airway Adapter as shown below:
Connect the Airway Adapter to the Ventilation System as shown below, then connect the
Mainstream CO2 Sensor to the Airway:
Summary of Contents for BM3Vet Pro
