User’s Reference Card
While seated, slightly extend your lower leg.
Tilt the top of the L300 Go FS Cuff toward you, and then slide it up your leg until the locator
rests below the kneecap. Lower the bottom of the L300 Go FS Cuff onto your leg.
Hold the L300 Go FS Cuff in place with your thumb or other hand on the EPG cradle.
Pull the strap handle around the cradle.
Figure 4 shows the L300 Go FS Cuff correctly placed on the right leg.
1
2
3
4
Putting On the L300 Go Functional Stimulation (FS) Cuff
European Authorized Representative:
Bioness Europe B.V.
Stationsweg 41
3331 LR Zwijndrecht, The Netherlands
Telephone: +31.78.625.6088
Email: [email protected]
Website: www.bioness.com
Worldwide Corporate Office
Bioness Inc
25103 Rye Canyon Loop
Valencia, CA 91355
Telephone: 800.211.9136
Email: [email protected]
Website: www.bioness.com
Operating the L300 Go System
Power Button
Stim Button
Battery Indicator Light
Charging Port
Plus Button
Status Indicator Light
Minus Button
612-00849-001
Rev
. A
™
1
2
3
4
Press the
on/off button to turn on the EPG.
Select either gait or training mode:
• To select gait mode, press the mode button briefly.
• To select training mode, press and hold the mode button for 10 seconds.
The EPG will acknowledge the new mode with audio and tactile feedback. Press
the mode button again to activate training mode. To exit training mode, press
and hold the
mode button for 10 seconds.
If necessary, adjust the stimulation intensity level by pressing the plus or minus
button.
1
2
3