Veterinary monitor user’s manual
Chapter 3-4
If the user intends to connect the monitor to the central monitoring system, plug its
connecting electrical cable into the Network Connector at the back of the monitor.
Note: This monitor can only be connected to the central monitoring system
provided by manufacturer, do not attempt to connect this monitor to other central
monitoring system.
3.4 Power on the Monitor
Press the power switch on the front panel of the monitor.
About 30 seconds after the monitor is switched on, after passing the
self-examination of the system, the monitor enters the monitoring screen.
Warning: In case the monitor is found to be working abnormally or indication
of errors appears, please do not use this monitor for monitoring and should contact
the after-sale service center as soon as possible.
3.5 Connecting to Various Kinds of Sensors
Connect sensor cables to the relevant sockets on the monitor and put sensors on the
monitored locations on the body of the patient. Refer to the relevant content of
Chapter 5
for details.
Warning: For safety reasons, all connectors for patient cables and sensor leads
(with the exception of temperature) are designed to prevent inadvertent
disconnection, should someone pull on the leads. Do not route cables in a way that
they may present a stumbling hazard. Do not install the monitor in a location where
it may drop to the patient. All consoles and brackets used must have a raised edge at
the front.
3.6 Preparation of Recorder
If the monitor you use has been provided with a recorder, before starting of
monitoring please check if the recorder has had recording thermal paper installed. The
thermal side (that is the smoother side) should face upwards and a small section should be
pulled out onto the outlet of the paper (on the right panel of the monitor).