Veterinary monitor user’s manual
Chapter 3-3
Note: This monitor contains a rechargeable battery. The average life span of this
type of battery is approximately three years. When replacement becomes necessary,
contacting a qualified service representative to perform the replacement.
Disposal Note: Should this product become damaged beyond repair, or for some
reason its service life is considered to be at an end, please observe all local, state, and
federal regulations that relate to the disposal of products that contain lead, batteries,
plastics, etc.
Install Battery
The battery storage is located at the bottom of the monitor, following the steps to install
a battery
.
1
、
Open the battery gate according to the direction marked on the monitor.
2
、
Turn the baffle up clockwise.
3
、
Push the battery into the gate with the electrode point to the bottom of the monitor.
4
、
After pushing the battery inside the storage withdraw, the baffle turn back to the
middle position.
5
、
Close the gate.
Uninstall battery
1、
Open the battery gate according to the direction marked on the monitor.
2
、
Turn the baffle up clockwise.
3
、
Take out the battery. Then close the gate.
3.3 Connecting to the Central Monitor System
Warning: Accessory equipment connected to the analog and digital interface
must be certified according to the respective IEC standards (e.g. IEC 60950 for data
processing equipment and IEC 60601-1:1995 for medical equipment). Furthermore
all configurations shall comply with the valid version of the system standard IEC
60601-1-1. Everybody who connects additional equipment to the signal input part or
signal output part configures a medical system, and is therefore responsible that the
system complies with the requirements of the valid version of the system standard
IEC 60601-1-1. If in doubt, consult the technical service department or your local
representative.