Biocare PM-900, User Manual, Page: 139 / 182

Chapter 15 Troubleshooting and Solutions
User Manual of Veterinary Monitor --127--
Chapter 15 Troubleshooting and Solutions
15.1 Check Before Use
Before use of the monitor, please perform the following inspections:

Check whether there is any mechanical damage.

Check all the exposed wires, inserts and accessories.

Ensure that the monitor is properly grounded.

Watch the voltage fluctuation of the local grid. If it exceeds the permissible range, it is suggested you add a
voltage stabilizing device.
If there is sign that the monitor function is damaged, do not use this equipment to monitor animal. In this case,
please contact the dealer or call us directly.
After each repair, a thorough inspection of the monitor must be done by a qualified technician.
Warning

The user shall not open the casing by you.

If the hospital does not implement the repair plan, it might cause the monitor to malfunction or even
cause risk to animal health.

If the sensor or cable has any sign of damage or deterioration, please stop using the equipment.

To eliminate unnecessary problems and avoid affecting the normal use, do not adjust the meters or
other adjustable elements inside the machine, unless otherwise permitted.
15.2 The Monitor cannot be Turned On

If AC power is used, check if the power cord is in good condition and if it has good contact with the monitor
and the power socket.

If DC power is used, check if the battery is correctly installed into the machine (refer to Chapter 12 Battery).
Please use AC power if the battery power is low.
If the equipment still cannot be turned on after above procedures, please contact the manufacturer.
15.3 The Monitor cannot be Shut Down Normally with ON/OFF Switch

Keep pressing ON/OFF for 3s or longer to shut down the equipment forcibly. (If the equipment cannot be
forcibly shut down, please unplug the power cord and remove the battery).

Restart the equipment and operate by going to [Main Menu]-[Animal Manage]-[Clear Animal Data].
If the equipment still cannot be shut down normally, please contact the manufacturer.