BIO RAD PowerPac Universal Power Supply, Instruction Manual

Page: 25 / 42

PowerPac Universal Power Supply Instruction Manual
Page | 17
Step Procedure Description
10. View the run information. After the run is complete, the Run Completed screen
appears.
3.4.2 Edit (or View) and Run a Saved Method
This section describes how to edit, view, and run a saved method. The procedure
below also describes how to create a new method derived from an existing method
Step Procedure Description
1. Set up the power supply. Refer to Section 3.1 for instrument setup.
2. Select the programming
mode.
On the Home screen, press the METHODS soft key to
access the Method List screen.
3. Open an existing method. On the Method List screen, use the up and down arrow keys
to select a method to edit and then press the OPEN soft key
to view the method.
4. Select a step to edit. Press the up or down arrow key to select the step you want
to edit, and then press the EDIT soft key to view the step
parameters.
NOTE: To edit the method name, use the up arrow key to
move to the method name and activate the name field. Use
the keypad to change the name as described in Step 4 of
Section 3.4.1 on page 14 .
5. Edit the selected step. Edit the step according to the process in Step 5 of Section
3.4.1 on page 15 .
6. Add additional steps to
the method.
For each additional step (up to nine total) complete the
following:
a. On the Method screen, press the down arrow to highlight
the next EMPTY step.
b. Complete the step definition procedure in Step 5 (page
15) .
After you are finished creating the necessary steps for the
method, proceed to Step 7 to save the method.