10
Bintec User’s Guide
Quick Reference
3
Configuration
cable, carry out a software update is described in the
Bintec User’s Guide
chapter
Gateway Management
(in the Basics section).
WLAN
As WLAN uses the air as transmission medium, the transferred data can theo-
retically be intercepted and read by anyone with the respective means. Thus,
safeguarding the radio link is to be paid special attention.
Follow the safety instructions for the WLAN configuration.
You can find information on how to secure your WLAN at
.
3.1
In Advance of Configuration
Only a few steps are necessary to prepare the configuration of your gate-
way: gather some information for the basic configuration (optional for In-
ternet access), configure the PC which is used to carry out the gateway
configuration, and install the
BRICKware
.
3.1.1
Gathering Information
The essential information for basic configuration with the
HTML Wizard
is
soon gathered, as no information is required that needs in-depth network
knowledge. If applicable, you can use the example values.
Before you start the configuration, you should gather the data for the following
purposes:
■
Basic configuration
(obligatory if your gateway is in the ex works state)
■
Internet access
(optional)
The following table shows examples of possible values for the necessary ac-
cess data. You can fill in the table with your personal data under the heading
"Your value", so that you can refer to these values later when needed.
quick_reference.book Page 10 Thursday, April 28, 2005 3:20 PM
