BinTec BIANCA/BRICK-XM, Getting Started, Page: 13 / 36

I
NSTALLING THE
BRICK
7
Upon successful completion of the self test, the BRICK
then switches into BOOTmonitor Mode, (the middle six
LEDs remain on) as described in the User’s Guide.
If the ERR indicator remains on (see table below) there
may be a problem with the cabling. Verify the ISDN and
LAN cabling is correct and power up the system again.
Also note that the once the rooter is up, the system may
be accessed via the ISDN using the factory-set passwords.
Changing the default passwords is described on page 15.
After 4 seconds, the system then switches into Normal
Operation Mode. During normal operation, the front
panel indicators display status information as follows.
LED State Meaning
PWR On
Power:
Power is being supplied.
Slots
1-3
–
The meaning of these LEDs depends
on the type of module installed in the
corresponding slot.
A detailed description can be found
in the BIANCA/BRICK-XM User’s
Guide.
ERR Blinking
Error:
Data transfer problem on one of the
slots. Check the cabling.
☞
☞