bintec elmeg H2 Auto Compact Series, Installation Manual, Page: 12 / 40

The Ethernet switch speed/state depends on the yellow and green LEDs combination:
Green LED Yellow LED STATUS
OFF OFF The interface is either unavailable, not installed or not re-
gistered.
OFF ON Connected to 10 M:
- Yellow steady: Not transferring data.
- Yellow blinking: Transferring data.
ON ON Connected to 100 M:
- Yellow and green steady: Not transferring data.
- Yellow and green blinking: Transferring data.
ON OFF Connected to 1000 M:
- Green steady: Not transferring data.
- Green blinking: Transferring data.
3.1.2 Rear panel
The following image shows the remaining connectors on the rear panel of the bintec H2 Auto Compact.
Fig. 5:
bintec H2 Auto Compact
: Rear panel
The rear panel components include:
Table 3: Rear panel components
Item Description
A WLAN 1 and WLAN 2 antenna connectors.
B GPS antenna connector.
C Cell 1 and Cell 2 antenna connectors.
D SIM trays 1 and 2. For more information on how to install SIM cards, see SIM card installation
on page 16.
3.2 Mounting options
The bintec H2 Auto Compact device can be vehicle-mounted or placed on a wall, ceiling or horizontal surface.
3 Components and power supply bintec elmeg GmbH
6 bintec H2 Auto Compact