Binder MKF 115, Operating Manual

Page: 66 / 115

MKF+ MKFT (E3.2) 07/2017 page 66/115
13. Notification and alarm functions
13.1 Notification and alarm system overview (auto diagnosis system)
•
Visual indications of notification or error messages are blue notes on the display of the MB1controller.
•
Visual indications of an alarm messages are red notes with an alarm bell symbol.
In addition, there is an audible alert, if you did not deactivate the buzzer in the “User level” menu
(chap. 6.4).
Event
Note
(blue field)
Alarm
(red field)
Lack of water in the freshwater can. The
chamber continues working for a few hours.
In case of freshwater supply via water pipe,
the water tap is closed, or the chamber is
defective.
WATER LOW
after 5 min
Wastewater hose clogged. Check the length
and location of the wastewater hose.
or
Wastewater pump or float switch in the
wastewater can defective. Contact BINDER
service.
WASTEWATER
after 10 sec.
Humidifying module defective. Contact
BINDER service.
FAULT HUMID SYSTEM
immediately
Freshwater can is too empty to allow normal
function, or the chamber is defective.
The humidification system turns off.
Fill up the water can or open the water supply.
During the one-hour preheating phase: mes-
sage without significance
WATER TANK EMPTY
after 60 sec.
When manually filling up the freshwater can:
Freshwater can is too full, or the chamber is
defective. Suck off the water (chap. 4.2.2).
The chamber functions as usual.
If the message persists, contact BINDER ser-
vice.
WATER LEVEL TOO
HIGH
after 60 sec.
Humidity switch OFF or humidity outside con-
trol range. No active humidification of the inte-
rior. Further dehumidification possible by re-
frigerating operation
HUMID OFF
immediately
Maintenance of the humidity module is re-
quired. Contact BINDER service.
HUMID SERVICE
immediately
One-hour preheating phase, no refrigerating
and dehumidification functions
1H PREHEAT PHASE
immediately
Fault in refrigerating machine. Contact
BINDER service.
FAULT COMPRESSOR
immediately