Binder MKF 115, Operating Manual

Page: 55 / 115

MKF+ MKFT (E3.2) 07/2017 page 55/115
9.7 Repetition of a section or several sections within a program
Here we use the example of a set-point ramp temperature program of chap. 9.5. The shaded sections 02
and 03 shall be repeated e.g. 30 times.
Section
Temperature
set-point
Fan Section time
Operation
lines
Target
section
No. of
cycles
Minimum
tolerance Maximum
tolerance
No. W-1 FAN Time Sk No Cy Tmin Tmax
01 -20 ****. 00:30:00 00000000 1 0 -1999 +9999
02 0 ****. 01:30:00 00000000 1 0 -5 +5
03 60 ****. 01:00:00 00000000 1 0 -2 +2
04 60 ****. 03:20:00 00000000 1 0 -1999 +9999
05 -40 ****. 00:00:01 00000000 1 0 -1999 +9999
The following table shows the program that results, whereby the differences to the table above are shad-
ed.
Section
Temperature
set-point
Fan Section time
Operation
lines
Target
section
No. of
cycles
Minimum
tolerance Maximum
tolerance
No. W-1 FAN Time Sk No Cy Tmin Tmax
01 -20 ****. 00:30:00 00000000 1 0 -1999 +9999
02 0 ****. 01:30:00 00000000 1 0 -5 +5
03 60 ****. 01:00:00 00000000 2 30 -2 +2
04 60 ****. 03:20:00 00000000 1 0 -1999 +9999
05 -40 ****. 00:00:01 00000000 1 0 -1999 +9999
Sections 02 and 03 will be executed in total 31 times; only then will the program continue.
Entry of the values into the display program table:
To have sections repeated indefinitely, enter the number of cycles “Cy” as -1.
9.8 Performance after power failure in Program Mode
The program is resumed at the point where the interruption occurred with the latest set-points reached
during the program run. The power failure is noted in the event list. No error message is displayed indicat-
ing that a power failure had taken place.
PGM
08:49:07 15.12.13