CB (E7) 06/2018
Page 78/174
10. Week programs
The MB2 program controller permits programming week programs with real-time reference. It offers 5
week program places in total with up to 100 shift points for each week program.
Path:
Main menu > Programs> Week program
10.1 Starting an existing week program
In Normal display press the
Program start
icon to access the “Program start” menu.
“Program start” menu.
•
In the field “Program type” select the setting “Week program”.
•
In the field “Program” select the desired program.
•
There are no further settings available in the “Program start” menu for week programs, as they are
needed only for time programs.
After completing the settings, press the
Confirm
icon to take over the entries and exit the menu. The
program starts running.
If instead you press the
Close
icon to exit the menu without taking over the entries, the program will not
start.
After starting the week program, the previously entered week program setpoints are active and will be
equilibrated according to the current time.
Information on the bottom of the screen indicates the
currently running program.
10.2 Cancelling a running week program
Press the
Program cancelling
icon to cancel the program.
A confirmation prompt is displayed. Press the
Confirm
icon to confirm that the program shall really be
cancelled.
After confirming the message the controller changes to Fixed value operation mode. Temperature and
humidity will then equilibrate to the setpoints of Fixed value operation mode.
Summary of Contents for CB 170
Page 165: ...CB E7 06 2018 Page 165 174 25 9 Dimensions CB 170 Dimensions in mm...
Page 167: ...CB E7 06 2018 Page 167 174...
Page 168: ...CB E7 06 2018 Page 168 174 27 Product registration...
Page 175: ......
