Binder 9040-0189, Operating Manual

Page: 69 / 119

CB-S / CB-S-UL (E7) 06/2020 page 69/119
IP address assignment (sample values).
The forth section of the IP address is shown. Enter the desired value
with the
arrow buttons .
Confirm the setting with the OK button .
IP address
With the arrow-down button you can now change to the enter the subnet mask.
With the Back button you can go back to the “ Ethernet ” submenu and, repeatedly pressing it, to Normal
display .
16.2.4 Setting the subnet mask
Access to this function is possible only if manual IP address assignment has been selected (chap. 16.2.1)
Path: Normal display Settings Ethernet Subnet mask
Press the OK button to enable the setting.
The subnet mask entry is done in four steps, corresponding to the number sections: (1).(2).(3).(4)
Principle of entry:
•
Use the OK button to select the desired section of the subnet mask 1/4, 2/4, 3/4, 4/4 in the upper
display line
•
Use the Arrow buttons to enter the value for the selected section of the subnet mask
For details please refer to the description of the similar procedure in chap. 16.2.3 “Assigning the IP ad-
dress”.
With the arrow-down button you can now change to the enter the standard gateway.
With the Back button you can go back to the “ Ethernet ” submenu and, repeatedly pressing it, to Normal
display .
16.2.5 Setting the standard gateway
Access to this function is possible only if manual IP address assignment has been selected (chap. 16.2.1)
Path: Normal display Settings Ethernet Standard gateway
Press the OK button to enable the setting.
The standard gateway entry is done in four steps, corresponding to the number sections: (1).(2).(3).(4)
Principle of entry:
•
Use the OK button to select the desired section of the standard gateway 1/4, 2/4, 3/4, 4/4 in the upper
display line
•
Use the Arrow buttons to enter the value for the selected section of the standard gateway
•
For details please refer to the description of the similar procedure in chap. 16.2.3 “Assigning the IP
address”.
With the arrow-down button you can now change to the assign the DNS server address.
With the Back button you can go back to the “ Ethernet ” submenu and, repeatedly pressing it, to Normal
display .