MK (E3) 07/2009
page 59/70
1) Lower values are valid at an ambient temperature of max. 25°C
/ 77°F
2) Depending on the set-point
3) to 98% of the set value
4) These values can be used for dimensioning air condition systems.
All technical data is specified for units with standard equipment at an ambient temperature of +25°C
/
77°F
and a power supply voltage fluctuation of +/-10%. The temperature data is determined in accor-
dance to factory standard following DIN 12880, observing the recommended wall clearances of 10 % of
the height, width and depth of the inner chamber.
All indications are average values, typical for units produced in series. We reserve the right to
alter technical specifications at all times.
If the cabinet is fully loaded, the specified heating up and cooling down times may vary ac-
cording to the load.
18.5 Equipment and Options
To operate the temperature test chamber, use only original BINDER accessories or accesso-
ries from third-party suppliers authorized by BINDER. The user is responsible for any risk
arising from using unauthorized accessories.
Regular equipment
Microprocessor display program controller
Programmable bedew protection of charging material
Door with window and interior lighting
Environmentally friendly refrigerant R404a
Temperature safety device class 2 acc. to DIN 12880
Internal socket 230 V AC 230V, 1N ~ 50-60 Hz, max. load 500W, protection type IP 54
Ethernet interface for computer communication
1 access port with silicone plug
diameter 50 mm left (MK 115, MK 240), 2 access ports with silicone plug
diameter 80 mm left and right (MK 720)
1 rack, stainless steel
Aeration / venting
Four castors (2 lockable)
Options / accessories
Additional rack, stainless steel
Perforated rack ,stainless steel
Reinforced rack with 1 set of rack lockings
Securing elements for additional fastening of racks (4 pieces)
Keyboard locking for MB1 controller (BINDER Individual)
Lockable door
Access ports 30mm, 50mm, 80mm, 100mm, 125mm, with silicone plug
Over-/under temperature safety device class 2
Analogue outputs 4-20 mA for temperature actual value and set-point value to 6 pole DIN connection
socket, DIN plug included
Additional measuring channel for digital object temperature display with flexible Pt100 temperature sen-
sor
Notch-type access port 35 x 100 mm in the door
Interface RS 422
4 zero-voltage relay outputs, addressable via operation lines
Factory calibration certificate
Extension to factory calibration certificate (additional value)
Measurement and protocol according to DIN 12880
Qualification folder
Summary of Contents for 9020-0146
Page 65: ...MK E3 07 2009 page 65 70 18 9 Dimensions MK 115 ...
Page 71: ......
