Installation Instructions - BMW F10 CarPlay MMI Prime
Setting up the DIP switches on the
MMI
The Multi Media Interface (MMI) included in your kit is a piece of equipment that allows for transfer of
additional video signals, other than the original iDrive view, onto your BMW's factory screen. In order
for the MMI module to work correctly the little DIP switches on the side of the MMI module must be
set up according to your vehicle's specifications.
Important Note: Every time you change DIP switch settings make sure to disconnect the MMI
modules POWER connector for 10 seconds. This will allow the new DIP switch settings to take effect.
After that you can reconnect the power cable.
DIP switch 1: Always ON
DIP switch 2: Always ON
DIP switch 3:
DIP switch 3 is responsible for correct cooperation between the MMI module and the factory screen,
ensuring that the image is displayed correctly with our device being connected between the original
head unit and screen.
For big 10.2” and 8.8” panoramic screens set 3 to ON
For the smaller 16:9 aspect ratio 6.5” screens set 3 to OFF
DIP switches 4-8: Default OFF
Remember to disconnect the MMI from power after changing the DIP switch setup.
BimmerTech FZE | Phone: +1(646) 439-7920 | www.bimmer-tech.net
7
