Bilancial D410, Use And Maintenance Manual, Page: 45 / 84

5.2.5 Memory status
If there is insufficient free memory, memory can be recovered by
following the pathway:
...>MENU>Memory status
CAUTION
The memory recovery operation may require a few minutes
during which time the terminal cannot be operated. Do not
switch off the terminal during this operation as this could
result in the loss of the data in memory.
5.2.6 Reprint
See par. 5.3.1 on page 1-53 .
5.2.7 Diagnostics (for digital scale only)
This user menu item is only available when there are digital cell errors (
par. 8.2 on page 1-80 ). It allows you to identify what caused the error.
Follow this path:
...>MENU>Diagnostics
If the instrument is not subject to calibration checks,
CONT
can be
pressed to display the measured weight despite the error.
Remember that this can only be done in the case of serial number errors
or ones due to non-configured digital cells.
The error message will reappear when the terminal is powered again
unless the cause of the error is eliminated.
D410
1-45