GUANGDONG ACES MACHINERY CO.,LTD
44
Ⅲ
.Electronic component maintenance
All equipment enclosure and components cleaning, replacement of spare parts must be
done when the equipment is shut down, and carried out by trained and qualified staff.
Make sure that these work must not be carried out in the boot state.
A. Enclosure cleaning
：
Every day before starting work, wipe all the enclosure of the
equipment, including the glass door with a rag dipped with alcohol or foam cleaner,
and do not use ink cleaning solution or other strong corrosive solution.
B. Electrical components:
clean up all electrical components of the equipment with
dust-free cloth dipped with alcohol once a month to ensure that there is no
excessive dust and dirt on the surface of the components.
C. Computer
：
Make a comprehensive anti-virus work on the computer once a week ,and
ensure that the anti-virus software is the latest version. Anything downloaded or
copied into the computer must be anti-virus processed first.Clean up the software in
the computer every half month to ensure that no unnecessary software is installed.
（
Apart from driving software, RIP software, and printing required pictures, it is not
allowed to install any other software in principle.It is also recommended that
equipment computer do not connect to the Internet. If necessary, it can be directly
connect to the intranet.Be careful to plug in external tools such as USB disk. Excessive
software will affect the use of the driver software and RIP software
）
.Make sure to
clean up computer garbage; do not use any other software during the machine
operation.
D. Ink bucket
：
Clean the ink bucket thoroughly every two months with cleaning solution.
When cleaning, turn off the power supply, unscrew the lid of the ink bucket and ink pipe
on the bucket(the ink pipe should be clamped by the hemostat first), remove the bucket,
wash it with pure water till no ink mark left, then wash it with cleaning solution.
E. Print-head moisturizing maintenance
：
Within 4 days of shutdown(including 4 days), add 3ml of cleaning solution or pure
water into cap(1.5ml in each grip, about level with the steps of the cap), then
moisturize, and observe to confirm whether the print-head and cap are sealed properly
after moisturizing the head carriage.
With 5 to 30 days of shutdown(including 30 days), separate the quick connector
of the upper end of the print-head(ink supply tube and recirculation tube end),clean
and dry the cap, then add 3ml(1.5ml in each grid) of the protection solution or