31
Step 8: Access Wall Assembly
Note: Pre-drill all holes using a 1/8” drill bit before installing the Lag Screws.
A:
On the ground lay flat 2 (2383) Posts then loosely attach (0348) SL Ground with 4 (H2) 1/4 x 2” Hex Bolts
(with lock washer, flat washer and t-nut); (2371) Floor End (in the top holes) and (1502) Wall Support with 2 (H2)
1/4 x 2” Hex Bolts (with lock washer, flat washer and t-nut) per board, as shown in fig. 8.1.
Keep bolts loose.
B:
Make sure assembly is square and then fasten (2371) Floor End to (2383) Posts with 2 (LS1) 1/4 x 1-1/2” Lag
Screws (with flat washer). (fig. 8.1)
C:
Tighten all bolts.
D:
Install one 1/4” T-nut into (2371) Floor End as shown in fig.8.1.
Notice the hole
locations
Wood Parts
Hardware
8 x
1/4 x 2” Hex Bolt (1/4” lock washer, 1/4” flat washer, 1/4” t-nut)
2 x
1/4 x 1-1/2” Lag Screw (1/4” flat washer)
1 x 1/4” t-nut
1 x
Wall Support 1 x 4 x 38-1/4”
2 x
Post 2 x 4 x 88”
1 x
Floor End 1 x 5 x 38-7/8”
1 x
SL Ground 1 x 5 x 38-1/4”
1502
0348
2371
2383
LS1
H2
1502
2371
Fig. 8.1
2383
0348
1/4” lock
washer
1/4” flat
washer
1/4” t-nut
LS1
H2
LS1
H2
1/4” flat
washer
H2
2383
H2
1/4” t-nut
Summary of Contents for HILLCREST F23270
Page 3: ...3 support solowavedesign com...
Page 4: ...4 support solowavedesign com...
Page 5: ...5 support solowavedesign com...
Page 110: ...110 support solowavedesign com NOTES...
