manualshive.com logo in svg

Biesemeyer 78-920 T-Square®, Instruciton

Share
Download
Biesemeyer 78-920 T-Square® Instruciton Download Page 1

1346214_RevB_11-10-07

SUPPLEMENTARY INFORMATION FOR THE DELTA

MODEL 36-790 RT-40 - 14" TILTING ARBOR SAW

BIESEMEYER

® 

(Model 78-920 T-Square

®

)

12" - 14" Table Saw Fence System 52-1/2" Capacity

IMPORTANT - The information in this document contains assembly and related instruction for your fence system. These 

instructions replace the information on pages 7 and 8 in your table saw instruction manual (Part #422-28-651-0001) Keep 

these supplemental instructions for future reference.

CARTON CONTENTS

1. 

Front Rail

2. 

Guide Tube

3. 

Fence Assembly

4. 

1/2"-13 x 2" Flat Head Bolts

5. 

5/16" Hex Wrench

6. 

1/2" Flat Washer

7. 

1/2"-13 Hex Nuts

8. 

Lockwasher

9. 

Retaining Nut

10. 

Retaining Nut Hex Bolt               

11. 

Retaining Nut Bolt 

1

2

3

4

5

6

7

11

9

8

10

Summary of Contents for 78-920 T-Square®

Page 1: ... instruction for your fence system These instructions replace the information on pages 7 and 8 in your table saw instruction manual Part 422 28 651 0001 Keep these supplemental instructions for future reference carton contents 1 Front Rail 2 Guide Tube 3 Fence Assembly 4 1 2 13 x 2 Flat Head Bolts 5 5 16 Hex Wrench 6 1 2 Flat Washer 7 1 2 13 Hex Nuts 8 Lockwasher 9 Retaining Nut 10 Retaining Nut H...

Page 2: ... rail 6 Insert a bolt A Fig 6 up through the hole B at the extreme right end of the guide tube Thread the retaining nut C on the bolt see the inset Fig 6 NOTE This retaining nut prevents the fence from falling off the end of the guide rail IMPORTANT Before applying power to the saw ensure that the rip fence is parallel to the miter gauge slot Refer to the section HOW TO OPERATE AND ADJUST THE RIP ...

Page 3: ...or until the witness line B is aligned with the previous measure ment Tighten the screws Fig 7 Fig 8 Fig 9 A B HOW TO ADJUST THE FENCE PARALLEL TO THE MITER GAUGE SLOTS IMPORTANT Be certain that the miter gauge slots are parallel with the blade before adjusting the fence Move the fence A Fig 10 until the bottom edge is aligned with the edge of one of the miter gauge slots and lock it in place with...

Page 4: ...Center at 1 800 782 1831 HOW TO ADJUST THE CLAMP HANDLE When the clamp handle is in the down position the fence will lock to the guide tube If this is not the case lift the clamp handle and raise the fence assembly off of the guide tube Slightly tighten the two adjusting screws E and F an equal amount using a 3 16 hex wrench Re place the fence assembly and check for correct clamp ing Repeat as nec...

Reviews:

No comments

Brands by name

Popular brands

Load more brands