Biddle SensAir, Manual

Page: 21 / 208

S
ENS
A
IR
M
ANUAL
I
NSTALLATION
Manual version 1.0- North America (13-09-2016) en-21
en
2.3 Hanging the unit up
2.3.1 Determining the location of the unit
Danger:
d
Do not install the unit in a vertical position.
• Make sure that the structure from which the unit is about
to be suspended can bear at least 4 times the weight of the
unit. The unit’s weight is indicated on its type plate.
• Note the following dimensions:
- The unit must be at least as wide as the door opening
(dimension b).
- Position the unit as near to the doorway as possible.
- Position the unit as close to the top of the door as pos-
sible.
- The IR sensor must be able to measure the tempera-
ture on the outdoor floor. (see 1.3.4 Position of IR
sensor )
Warning:
w
The minimum installation height is 1.8 m
(6 ft).
Note:
n
The maximum mounting height of the unit
(dimension h, measured from the floor to the
discharge grille) depends on the unit type.
Warning:
w
The top of the unit may get hot. The unit
must be positioned with at least 25 mm (1")
clearance from the ceiling (dimension x).
See also:
1.3.6 "Type plate" on page 14
"Position of IR sensor" on page 11