NOZ2 M
ANUAL
S
ERVICE
Manual version 6.0 - North America (10-03-2017)
en-79
en
4. Press down microswitch.
The LED next to the microswitch will stop flashing.
The unit code is now set.
5. Reset the control panel.
7.8
Resetting the PIN code
The PIN code of the control panel can be reset using a USB
flash drive:
1. Connect a USB flash drive to the control panel.
The USB menu is activated
2. Press
x
for 10 seconds.
The PIN code is reset and a new PIN code has to be
entered.
3. Exit the USB menu by removing the USB flash drive.
7.9
Copying the settings
The settings of the unit can be copied to another unit.
7.9.1 What you need
Before copying the setting, check that you have the following:
• An empty USB flash drive. The USB flash drive must be for-
matted for FAT or DOS. Do not use a USB hard disk for
the software update.
7.9.2 Step 1: Copying the settings of the correctly-set
unit
1. Check whether the settings to be copied on the original b-
touch control panel are all correctly set.
2. Connect the USB flash drive to the USB port of the b-
touch control panel.
Note:
n
If the USB flash drive is not detected, disconnect it
and then connect it again.
The control panel detects the USB flash drive and displays
the USB menu
